Panasonic WJ-GXE500E Operating Guide
46
Important:
*4
• When "Alarm input" or "Manual" is selected for "Save trigger" on the [SD memory card] tab, images will
not be transmitted to the FTP server even when an alarm is detected.
*7
• Depending on the network line speed or the network traffic, images may not be transmitted at the exact
designated interval or period.
*1
• "Alarm input", "Alarm output" and "Command alarm" are activated for the selected channel.
*2
• Refer to the installation guide for further information about input/output rating of each terminal.
*3
• The following port numbers are unavailable since they are already in use.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 554, 995, 10 669, 10 670, 52 000,
59 000 - 61 000
59 000 - 61 000
*5
• To transmit alarm images to an FTP server, it is necessary to configure the settings in advance. (☞ Page
52)
*6
• When "D1" is selected for "Image capture mode", Alarm FTP image transmission is unavailable.
*8
• The values (transmission interval x number of images) will automatically be set.
*9
• When "Open" is selected, the alarm signal will be output for around 20 seconds when the power of the
unit is turned on.
[VMD area] tab
Refer to page 28 for general information about this tab.
Setup items
Setting values
(Underlined: default)
(Underlined: default)
Ch No.
1/2/3/4
Area
1 (White) / 2 (Blue) /
3 (Green) / 4 (Red)
3 (Green) / 4 (Red)
Status
On/Off
Detection area
1 - 10 (Default: 1)
Detection sensitivity
1 - 15 (Default: 8)
VMD information addition
Information addition *1 *2
On/Off
Important:
• The alarm occurrence indication button (☞ page 13) will be displayed when motion is detected by the VMD
function.
• The alarm occurrence indication button will be displayed when receiving an alarm input of a terminal alarm or a
command alarm.
• Depending on the network environment, notification may be delayed even when "Real time" is selected for
"Alarm status update mode" on the [Basic] tab of the "Basic" page (☞ page 30).
• The motion detection function is not the dedicated function to prevent thefts, fires, etc. We are not responsible
for any accidents or damages occurring in case.
• When "Multicast" is selected for "Transmission type" on the [JPEG/H.264] (☞ page 34) (or [JPEG/MPEG-4]
(☞ page 37)) tab or "On" is selected for "Priority stream" on the [System] tab, it may sometimes be impossible
to display the VMD area setup window.
to display the VMD area setup window.