Panasonic WJ-GXE500E Operating Guide
48
[Notification] tab
Refer to page 28 for general information about this tab.
Setup items
Setting values
(Underlined: default)
(Underlined: default)
Mail notification
Mail notification
On/Off
Destination of notification
Address1 - 4
Alarm *1
On/Off
Diag. *2
On/Off
Destination address
(Default: None (blank))
Mail subject
(Default: None (blank))
Mail body *3
(Default: None (blank))
Panasonic alarm protocol
notification
notification
Panasonic alarm protocol *4
On/Off
Destination port *5
1 - 65 535 (Default: 1 818)
Retry times
0 - 30 (Default: 2)
Destination of notification
*6
*6
Address1 - 3
Alarm *7
On/Off
Diag. *8
On/Off
Destination IP address
(Default: None (blank))
Important:
*6
*6
• When a device does not exist on the registered IP address, notification may be delayed.
*1
• The mail notification will be performed upon an alarm occurrence.
*2
• Mail notification will be provided in the following cases.
• When it is configured to notify users of available capacity of the SD memory card
• When the capacity of the SD memory card has become insufficient
• When the SD memory card has failed to mount
• When the video loss is recovered
• When the capacity of the SD memory card has become insufficient
• When the SD memory card has failed to mount
• When the video loss is recovered
*3
• Notification mail will be sent with the following message. (The message to be sent differs depending on
the status of the SD memory card.)
• "The SD memory card is full." (This message will be sent when the SD memory card becomes full.)
• "The SD memory card cannot be recognized." (This message will be sent when the SD memory card
• "The SD memory card cannot be recognized." (This message will be sent when the SD memory card
has failed to mount.)
*4
• When "On" is selected, notification of the alarm occurrence will be provided to the registered destination
addresses in order (to IP address 1 first, to IP address 3 last).
*5
• The following port numbers are unavailable since they are already in use.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 123, 161, 162, 995, 10 669, 10 670
*7
• The Panasonic alarm notification will be provided upon an alarm occurrence.
*8
• Maintenance requirement will be notified in the following cases.
• When it is configured to notify users of available capacity of the SD memory card
• When the capacity of the SD memory card has become insufficient
• When the SD memory card has failed to mount
• When the video loss is recovered
• When the capacity of the SD memory card has become insufficient
• When the SD memory card has failed to mount
• When the video loss is recovered