Beko GNE 60520 DX User Manual

EN

13

If you want to use your refrigerator by 

connecting it to the cold water mains 

line, 
you will have to connect a standard 

1/2" valve connection fitting to the cold 

water supply in your house. In case 

this valve is not present or in case 

you are not sure, consult a qualified 

plumber.
1.  Separate the union from the tap 

adaptor. (Figure A) 

2.  Install the tap adaptor to 1/2” valve 

fitting as shown in the figure. (Figure 

B) 

3.  After inserting the water pipe to the 

union, install it to the tap adaptor 

and insert to the tap as shown in the 

figure.     (Figure C) 

4.  Tighten the union manually. In case of 

a leak use a spanner or a pair of pliers 

to tighten the union. 

A

 Caution: Secure the water pipe 

to suitable points by means of the 

pipe clips supplied to avoid any 

damage or displacement or accidental 

disconnection.

A

 Caution: After turning on the water 

valve, make sure that there is no 

leakage at both connection points of 

the water pipe. In case of a leak, turn 

off the valve immediately and tighten all 

joints again using a spanner or a pair 

of pliers.

A

 Caution: Make sure that standard 

1/2" valve fitting fed by cold mains 

water supply is available and is turned 

off fully. 
To fit the water filter follow the 

instructions below referring to figures 

supplied: