DELL 7x0N User Manual

You might want to note the unit number for any ATM adapters you plan to configure in 
the near future. You can also perform the adinfo command again at any time to deter-
mine the correct unit number.

' $##

The ATM adapter in your filer should be properly connected using the appropriate 
cabling. To check that your filer has a working physical connection to your ATM net-
work, use the 

 command.

Command syntax: The 

 command has the following syntax:

%

device is the name of the particular ATM adapter whose connection you want to 
check.

The following command displays statistics about the ATM adapter in slot 1 of your 
filer:

%

The sample output from this command is as follows:

$&'% % '%

( ' %

)*+)*+

Interpreting the output: Verify that the 

Carrier

 is 

ON

 in the output. If the 

Carrier

 is not 

ON

, your cabling is either incorrectly connected or faulty, or your 

ATM network is malfunctioning or misconfigured.

If you need information about connecting the cabling to your filer’s ATM adapter, refer 
to the enclosed ATM installation guide.

" ' *)!

To check whether the UNI is operational, use the uniconfig command.

Because the filer’s ATM address is automatically registered with the switch, you only 
use the uniconfig command to display configuration parameters, check the UNI ver-
sion number, and ensure that the UNI is operational. 

Command syntax: The uniconfig command has the following syntax:

',%-.

65CNPbk0.book  Page 7  Monday, September 13, 1999  1:43 PM