DELL 7x0N User Manual
20
Dell PowerVault 7x0N Systems — Connecting to ATM and FDDI Networks
! # /* . +$ /!
To establish an incoming FORE/IP PVC on the filer, use the following command at the
filer:
filer:
2+
C
C
DD
Use the variables as described in Table 2.
! /* . +$ # 0
Set up a FORE/IP PVC on the remote ATM host according to the documentation for
that host.
that host.
! /* . +$
On the interconnecting ATM switches, assign virtual channels corresponding to the
VPI and VCI entries made on the filer and the remote ATM host according to the doc-
umentation for those switches.
VPI and VCI entries made on the filer and the remote ATM host according to the doc-
umentation for those switches.
)! # " /* . +$
To display information about all FORE/IP PVCs and other interfaces on a host, type the
following command:
following command:
2+
hostname
is the name of a host.
aal
ATM adaptation layer type. It must be 4 or 5, and should be the
AAL type supported by the destination host, which is typically 5.
The default is 5.
AAL type supported by the destination host, which is typically 5.
The default is 5.
encap
Encapsulation type. Specify one of the following encapsulation
types:
types:
null (no encapsulation; this is the default)
llc_routed (IEEE LLC encapsulation for routed power distribu-
tion units [PDUs])
tion units [PDUs])
llc_bridged_8023 (IEEE LLC encapsulation for Ethernet/802.3
bridged PDUs)
bridged PDUs)
It should also be the same as the encapsulation type used by the
destination host.
If the encapsulation type is llc_bridged_8023, you must include addr.
destination host.
If the encapsulation type is llc_bridged_8023, you must include addr.
addr
Six-byte colon-separated destination MAC address.
65CNPbk0.book Page 20 Monday, September 13, 1999 1:43 PM