Festool PD561287 User Manual

11. 

Measure the length of the fourth offcut. The accuracy 

of this measurement is not critical, so a standard tape 
measure or ruler will suffice. 

12. 

Measure the width of the fourth offcut at both ends (as 

labeled “Right” and “Left”). These two measurements 

are critical, so use the best method you can.  

 

Supplemental User’s Manual 

27 

The equation for calculating the error is shown below, 

however, the electronic version of this manual also 

contains a built-in calculator. To use the calculator, enter 

your measurements (in either mm or inches) in the boxes 
and click on the “Calc Error” button. The calculated error 

(angle) is displayed to the right of the button. 

⎥

⎦

⎤

⎢

⎣

⎡

−

×

=

sin

4

1

 

Width Left   

Width Right 

 

Length  

 

► 

If the answer is a negative number (Right side wider 

than Left side), then your saw is cutting too much to 

the left of center.  

► 

If the answer is a positive number, your saw is cutting 
too much to the right of center. 

1. 

Using the hex key stored on the cord reel, slightly 

loosen the two adjusting screws located behind the 
cord reel shown below. 

2. 

You may find it easier to move the entire saw head 

instead of just the bevel plate. To move the entire saw 

head, leave the bevel lock lever (see page 13) in the 
locked position. To move just the bevel plate, move 

the bevel lock lever to the unlocked position. 

3. 

Carefully adjust the bevel angle to account for the 
error calculated previously. 

4. 

Retighten the two screws, and repeat the procedure to 

verify the results. 

5. 

When the calibration is correct, torque the two screws 

to 18 ft. lbs. (25 Nm).