Bosch 4410L User Manual

The switch handle can be positioned in any of four
different orientations, depending on the cutting 
situation and user preference:

a. Vertical b. 45° Left c. Horizontal d. 45° Right

To reposition the main handle: 

1. Release handle lock clamp.

2. Pull and hold handle rotation release lever 

3. Rotate handle to desired location.

4. Let go over release lever to set handle into

place. Release lever will retract down only in
one of the four (4) positions

Note: Power switch can not be actuated unless
release lever is retracted down. Do not attempt to
switch tool on between handle position, damage may
occur.

5. Lock the handle clamp.

1. Open handle lock clamp.

2. Using 1.5 mm Allen wrench, increase tension by

turning both setscrews 1/4 turn to the left, tighten
by turning to the right. Always adjust both
setscrews by the same amount.

3. Close handle lock clamp.

4. Check the tension.

If necessary, clamp the miter saw to a workbench or
table top by placing two (2) or more “C” clamps on
the clamping areas and secure.

NOTE: Be careful not to place clamps over the base
extension clamping levers.

Mounting with clamps will prevent access to some
wide miter angles.