Wagner SprayTech 9175 User Manual

English

Preparing the Sprayer

All new units are performance-tested at the factory and are shipped with test fluid in the fluid section to prevent corrosion

during shipment and storage. If you have already used your pump, some water or solvent used in cleaning may remain

in the fluid section. Whether your sprayer is new or if you have already used it, this fluid must be purged and thoroughly

cleaned out of the system prior to use. Follow the steps below.

1. Remove oiler cap using a straight-

slot screwdriver. Squirt separating

oil P/N 0516913 supplied with

your sprayer into the oiler

(approximately 1 ounce). Light

household oil can be substituted if

necessary. Replace cap.

2. After filling, push button on front of

face plate 2-5 times to lubricate the

fluid section. Press once for every

eight hours of usage. Be sure to

check reservoir level (a) and refill as

necessary.

4. Place a full container of spraying material underneath

the suction tube (a). Secure the return tube (b) into a

waste container.

6. Plug in the sprayer and move the ON/OFF switch to the

ON (l) position.

3. Fully depress the pusher stem to

make sure the inlet ball is free.

5. Turn the pressure control dial to maximum pressure (+).

Turn the PRIME/SPRAY knob to PRIME.

7. Switch the pump OFF (O). Remove the return tube from

the waste container and place it in its operating position

above the container of spraying material. Use the metal

clip to bind the two hoses together.

(a)

(b)

(a)

SPRAY

The unit will begin to draw material up the suction tube,

into the pump, and out the return tube. Let the unit cycle

long enough to remove test fluid from the pump, or until

spray material is coming from the return tube.

9155, 9175 and 9195 only.