Wagner SprayTech 110v User Manual

 

DISPLAYS AT THE UNIT / CLEANING THE UNIT

A clean state is the best method of ensuring operation with-

out problems. After you have finished spraying, clean the unit. 

Under no circumstances may coating material rests dry and 

harden in the unit. The cleaning agent used for cleaning (only 

with a flash point above 21 °C) must be suitable for the coat-

ing material used.

•  Secure the spray gun, refer to the operating manual of 

the spray gun.

 

Remove and clean the tip.

1.  Set multifunction switch to 

 (ON - circulation).

2.  Remove suction tube from the material container, the re-

turn tube remains over the material container. 

3.  Immerse the suction system into a container filled with a 

suitable cleaning agent

4.  Turn the pressure control valve back in order to set a mini-

mal spraying pressure.

5.  Set multifunction switch to 

 (spray).

6.  Pull the trigger guard of the spray gun in order to pump 

the remaining coating material from the suction hose, 

high-pressure hose and the spray gun into an open con-

tainer (if appropriate, increase the pressure at the pressure 

control valve slowly in order to obtain a higher material 

flow).

The container must be earthed in case of 

coating materials which contain solvents.

Caution! Do not pump or spray in container 

with small opening (bunghole)!

See safety regulations.

7.  Set multifunction switch to 

 (ON - circulation).

8.  Pump suitable cleaning agent in the circuit for several 

minutes.

The cleaning effect is increased by alterna-

tively opening and closing the spray gun.

9.  Set multifunction switch to 

 (spray).

10.  Pump the remaining cleaning agent into an open contain-

er until the pump is empty. 

11.  Switch off the unit

Warm water improves the cleaning effect in 

the case of water-dilutable coating materials.

1.  Set multifunction switch to 

 (ON - circulation).

2.  Turn the pressure control valve back in order to set a mini-

mal spraying pressure.

3.  Set multifunction switch to 

 (spray).

4.  Pull the trigger guard of the spray gun in order to pump 

the remaining coating material from the hopper, high-

pressure hose and the spray gun into an open container (if 

appropriate, increase the pressure at the pressure control 

valve slowly in order to obtain a higher material flow).

The container must be earthed in case of 

coating materials which contain solvents.

Caution! Do not pump or spray in container 

with small opening (bunghole)!

See safety regulations.

5.  Fill up hopper with suitable cleaning agent.

6.  Set multifunction switch to 

 (ON - circulation).

7.  Pump suitable cleaning agent in the circuit for several 

minutes.

8.  Switch reverser knob into a horizontal position.

 

The cleaning agent will flow around the circumference of 

the inner hopper wall and will clean it in some minutes, 

depending of the fouling

9.  Switch reverser knob into the upright position.

 

Cleaning agent is flowing directly into the hopper

Do not switch the reverser knob at the clean-

ing ring into the horizontal position when 

the pump is loaded with coating material. 

The holes could be plugged.

As a result the cleaning function will be re-

duced, as the cleaning ring has to clean itself 

first.

10.  Set multifunction switch to 

 (spray).

11. Pump the remaining cleaning agent from the hopper, 

high-pressure hose and the spray gun into an open con-

tainer 

12.  Set multifunction switch to 

 (ON - circulation).

13.  Switch off unit