Wagner SprayTech 110v User Manual

 

Move the spray gun evenly during the spraying process. If this 

is not observed, an irregular spraying appearance will be the 

result. Carry out the movement with the arm, not with the 

wrist. A parallel distance of approx. 30 cm between the tip and 

the surface to be coated should always be observed.  The lat-

eral limitation of the spray fan should not to be too distinct. 

The edge of spraying should be gradual to facilitate overlap-

ping of the next coat. The spray gun should always be held at 

an angle of 90° to the surface to be coated. A spray fan aimed 

obliquely at the surface to be coated leads to an unwanted 

spray cloud.

To achieve perfect surfaces at varnishing works, special acces-

sories are available at Wagner, e.g. FineFinish tips or an AirCoat 

gun set. Your Wagner dealer will advise you.

The unit is equipped with a high-pressure hose specially suit-

ed for diaphragm pumps.

Danger of injury through leaking high-

pressure hose. Replace any damaged high-

pressure hose immediately.

Never repair defective high-pressure hoses 

yourself!

The high-pressure hose is to be handled with care. Avoid sharp 

bends and folds: the smallest bending radius is about 20 cm.

Do  not drive over the high-pressure hose. Protect against 

sharp objects and edges.

Never pull on the high-pressure hose to move the device.

Make sure that the high-pressure hose cannot twist. This can 

be avoided by using a Wagner spray gun with a swivel joint 

and a hose system.

When using the high-pressure hose while 

working on scaffolding, it is best to always 

guide the hose along the outside of the scaf-

folding. 

The risk of damage rises with the age of the 

high-pressure hose.

Wagner recommends replacing high-pres-

sure hoses after 6 years.

Only use WAGNER original-high-pressure 

hoses with internal heating in order to ensure 

functionality, safety and durability.

1.  Switch off unit, set multifunction switch to 

 (pressure 

relief, circulation), then to 

 (OFF).

2.  Pull trigger guard of spray gun to decrease the pressure of 

the high pressure hose and the spray gun.

3.  Secure the spray gun, refer to the operating manual of the 

spray gun.

4.  Remove tip from tip holder and store the tip in a small ves-

sel with suitable cleaning agent. 

5.  Leave the suction system immersed in the coating mate-

rial or immerse it in the corresponding cleaning agent. 

The suction filter and unit should not dry out.

6.  Cover the material container in order to prevent the paint 

from drying.

In using quick-drying or two-component 

coating materials, do not fail to rinse unit 

through with a suitable cleaning agent dur-

ing the processing period.

SPRAYING TECHNIQUE / HANDLING THE HIGH-PRESSURE HOSE / INTERRUPTION OF WORK