Makita GA5041C User Manual

P 10/ 14

DISASSEMBLING

(1) Remove Rear cover from Motor housing by removing 4x18 Tapping screw. (Fig. 2)

(2) Disassemble Switch lever and Switch knob from the machine as drawn in Fig. 11.
Fig. 11

ASSEMBLING

(1) Insert Switch lever into Motor housing.  And push it until the loop portion comes into sight through Switch knob

      assembling hole on Motor housing. Refer to the right and center illustration in Fig. 11.

(2) Assemble Switch knob to Switch lever as drawn in Fig. 12.

1. Make sure that Compression spring 4 is assembled

    to Switch lever in advance.

2. Fitting Switch knob to the loop portion of Switch

    lever and the claw portion of Switch plate, hold 

    Switch knob. And then, release Switch lever.

    (The hook of Switch knob interlocks with the hole

     of Switch lever when Switch lever is pushed back

     to OFF position by Compression spring 4.)

Switch knob

Switch lever

Switch plate

Switch lever

Compression spring 4

3. Bending Switch lever, pull out

    Switch lever from Motor housing.

1. While locking Switch knob 

    with 1R281, strongly push

    Switch lever in a direction

    designated with black arrow.

2. Switch lever is disconnected from

    the locking claw of Switch knob.

    Then, remove Switch knob. 

1R281

Switch lever

Switch knob

Switch lever