Chauvet 1-TRI IP User Manual
Setup
-6-
COLORado™ 1-Tri IP User Manual Rev. 01c
3. Setup
AC Power
The COLORado™ 1-Tri IP has an auto-ranging power supply that can work with an
input voltage range of 100~240 VAC, 50/60 Hz.
input voltage range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the
specifications in this guide, the product’s user manual, or on the product’s sticker.
specifications in this guide, the product’s user manual, or on the product’s sticker.
Always connect the COLORado™ 1-Tri IP to a protected circuit with an
appropriate electrical ground to avoid the risk of electrocution or fire.
appropriate electrical ground to avoid the risk of electrocution or fire.
To determine the power requirements for the COLORado™ 1-Tri IP see the label affixed
to the side of the fixture. Alternatively, you may refer to the corresponding specifications
chart in the Technical Information chapter of this manual.
to the side of the fixture. Alternatively, you may refer to the corresponding specifications
chart in the Technical Information chapter of this manual.
The listed current rating indicates the maximum current draw during normal operation.
For more information, you may download the “Sizing the Circuit Breakers” document
from the CHAUVET® Web site.
For more information, you may download the “Sizing the Circuit Breakers” document
from the CHAUVET® Web site.
Never connect the COLORado™ 1-Tri IP to a rheostat (variable resistor) or dimmer
circuit, even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
circuit, even if the rheostat or dimmer channel serves only as a 0 to 100% switch.
AC Plug
Each COLORado™ 1-Tri IP has IP66 rated cords for Power In and Power Out with
proprietary IP66 connectors. These power cords access the sealed body of the fixture
through IP66 cable glands. To allow connection to power outlets, the fixture comes with
a power input cord with a proprietary IP66 connector on one end and an Edison plug on
the other end (US market). In case you need to replace the Edison plug on the power
input cord, follow the table below.
proprietary IP66 connectors. These power cords access the sealed body of the fixture
through IP66 cable glands. To allow connection to power outlets, the fixture comes with
a power input cord with a proprietary IP66 connector on one end and an Edison plug on
the other end (US market). In case you need to replace the Edison plug on the power
input cord, follow the table below.
Connection
Wire (US)
Wire (Europe)
IP66 Pin
Screw Color
AC Live
Black
Brown
1
Yellow or Brass
AC Neutral
White
Blue
2
Silver
AC Ground
Green/Yellow
Green/Yellow
3
Green
Power Linking
The COLORado™ 1-Tri IP supports power linking for up to 12 other COLORado™ 1-Tri
IP fixtures at 120 VAC. The fixture also comes with an IP66 power linking cord to allow
direct connection between fixtures.
IP fixtures at 120 VAC. The fixture also comes with an IP66 power linking cord to allow
direct connection between fixtures.
Fuse Replacement
The COLORado™ 1-Tri IP fixture has no external fuse that the user can change.
However, it does have an internal fuse that only an authorized CHAUVET® technician
should change.
However, it does have an internal fuse that only an authorized CHAUVET® technician
should change.