Panasonic WV-NP472 User Manual

-28-

Secondary server

Set the IP address of DNS when using the DNS server.

Refer to your internet Internet service provider for the IP

address of the DNS. Primary and secondary IP addresses

can be set for the DNS.

DHCP

Set to ON if your internet Internet service provider uses a

DHCP server (the DHCP server assigns an IP address to the

camera automatically) after confirming that your internet

Internet service provider uses a DHCP server.

Connection type 4

IP address

The setting differs depending on the setting of the router as

follows.

If the router uses DHCP: No setting required

If the router does not use DHCP: Assignment of a private IP

address to the router is required. However, the IP addresses

already assigned to the PC and other cameras are not avail-

able.

For further information, refer to the operating instructions of

the router.

Subnet mask

The setting differs depending on the setting of the router as

follows.

If the router uses DHCP: No setting required

If the router does not use DHCP: Setting of the subnet mask

is required.

For further information, refer to the operating instructions of

the router.

Default gateway

The setting differs depending on the setting of the router as

follows.

If the router uses DHCP: No setting required

If the router does not use DHCP: Assignment of an IP

address to the router is required.

For further information, refer to the operating instructions of

the router.

Network speed

Set the network speed.

Use the default setting “auto” for the network speed.

Selectable parameters: auto (default setting), 100 Mbps (full

duplex), 100 Mbps (half duplex), 10 Mbps (full duplex), 10

Mbps (half duplex)

HTTP port

If multiple cameras are connected, it is required to set up

each camera individually.

However, the port numbers already assigned to other hard-

ware are not available.

The following are already assigned to the camera.

Port number: 20, 21, 23, 25, 53, 67, 38, 80, 546, 547

The following are not usable if the FTP client function is set to

on.

Port number: from 4000 to 5000

The following is not usable if the custom alarm function is set

to on.

Port number: number already assigned to the custom

alarm.