Indesit KP9F11S/G User Manual

Disconnect your appliance from the electricity supply

before carrying out any work on it.

!

 Do not use abrasive or corrosive detergents (for

example, products in spray cans for cleaning

barbecues and ovens), stain removers, anti-rust
products, powder detergents or sponges with

abrasive surfaces: these may scratch the surface
beyond repair.

!

 Never use steam cleaners or pressure cleaners on

the appliance.

To extend the life of your oven, it must be cleaned
frequently, keeping in mind that:

• The self-cleaning panels (if present) and the

enameled parts should be washed with warm water
- abrasive powders and corrosive substances

should be avoided;

• The inside of the oven should be cleaned

immediately after use with warm water and soap;
the soap should be rinsed away and the interior

dried thoroughly;

• Stainless steel can be stained if it remains in

contact with agressive detergents (containing
phosphorus) or water with a high lime content. We

recommend that you rinse these parts thoroughly
and dry them well after cleaning. It is also a good

idea to dry any water spills;

• Never line the bottom of the oven with aluminium foil

because the buildup of heat will not only impede
the cooking process, but could also damage the

enamel.

• Cutoff the supply of power to the oven by turning off

the omni-polar switch connecting it to the mains, or

by removing the plug if it is accessible;

• Unscrew the glass cover attached to the lamp

holder;

• Unscrew the lamp and replace it with another high-

temperature lamp  (300°C) with the following
characteristics:

- Voltage: 230/240 V

- Wattage: 15W
- Socket: E14

• Remount the glass cover

and reconnect the
appliance to the power

supply.

Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry

thoroughly with a soft cloth. Do not use rough abrasive
material or sharp metal scrapers as these could

scratch the surface and cause the glass to crack. To
clean more thoroughly, you can remove the oven door:

• Open the door completely and lift the 2 levers “B”;

• Now, shutting the door slightly, you can lift it out by

pulling out the hooks “A” as shown in figure.

To reassemble the door:

• With the door in a vertical position, insert the two

hooks “A” into the slots;

• Ensure that seat “D” is hooked perfectly onto the

edge of the slot (move the oven door backwards
and forward slightly);

• Keep the oven door open fully, unhook the 2 levers

“B” downwards and then shut the door again.