Bunn AF PR-3 User Manual

9

FIG. 4 FUSE HOLDER

 

P1561

Location:

 

The fuse holder is located on the lower right 

front of the autofill box just to the left of the power 

cord.

Test Procedure:

1.  Disconnect the dispenser from the power source.

2.  Remove cap and fuse from fuse holder.

3.  Remove fuse from the cap.

4.  Check for continuity through the fuse.

If continuity is present as described, reinstall the fuse, 

the fuse is operating properly.

If continuity is not present as described, replace the 

fuse.

 

28791.1 011500

BLK from Main

Wiring Harness

BLK to Main

ON/OFF Switch

FIG. 5 FUSE HOLDER TERMINALS

P1331

Removal  and Replacement:

Fuse:

1.  Remove the cap from the fuse holder.

2.  Remove fuse from the fuse holder, inspect, if blown 

discard.

3.  Install new 10 amp fuse in the fuse holder.

4.  Reinstall fuse holder cap.

Fuse Holder:

1.  Disconnect the wires from the rear of the fuse 

holder.

2.  Remove the nut securing the fuse holder to the 

front of the main mounting panel.

3.  Push the fuse holder through the hole in the panel.

4.  Install new fuse holder and fuse through the hole 

in the panel.

5.  Secure the fuse holder to the panel. 

6.  Refer to Fig 5 and reconnect the wires.