Hoshizaki KML-700MWH-M User Manual

7

1. This icemaker must be installed in accordance with applicable international, 

national, state, and local regulations.

. 

CHOKING HAZARD: Ensure all components, fasteners, and thumbscrews 

are securely in place after installation. Make sure that none have fallen into 
the dispenser unit/storage bin.

• Visually inspect the exterior of the shipping container and immediately report any 

damage to the carrier. Upon opening the container, any concealed damage should also 
be immediately reported to the carrier. 

• Remove the shipping carton, tape, and packing material. If any are left in the icemaker, 

it will not work properly.

• Remove the panels to prevent damage when installing the icemaker. See "II.B. How to 

Remove Panels."

• Remove the package containing the accessories.
• Remove the protective plastic film from the panels. If the icemaker is exposed to the 

sun or to heat, remove the film after the icemaker cools.

• Check that the refrigerant lines do not rub or touch lines or other surfaces.
• Check that the compressor is snug on all mounting pads.
• See the nameplate on the rear panel, and check that your voltage supplied 

corresponds with the voltage specified on the nameplate.

• This icemaker can be installed on a dispenser unit or storage bin 30" wide or wider. For 

options, contact your local Hoshizaki distributor. 

• Front Panel: Remove the screw. Lift up 

and towards you.

• Top Panel: Lift up at front slightly, push 

rearward, and lift off.

• Side Panel (R): Remove the screw. Slide 

forward slightly and lift off.

• Front Insulation Panel: Lift up slightly, and 

pull towards you.

• Top Insulation Panel: Lift off.

Top Panel

Front Insulation Panel

Front 

Panel

Screw

Screw

Side 

Panel 

(R)

Top Insulation Panel