Tektronix AWG710B User Manual
Synchronous Operation Mode (AWG710B only)
AWG710&AWG710B Arbitrary Waveform Generator User Manual
3-253
Setup screen
Figure 3-88: Synchronous Operation mode screen
Status area: Mst or Slv mark is displayed and it indicates that the instrument
is Synchronous Operation mode.
is Synchronous Operation mode.
Connection: The connection state of Master and Slave is displayed. When
connecting, the IP address of a partner’s unit is displayed. When not
connecting, it is displayed as Not Connected.
connecting, the IP address of a partner’s unit is displayed. When not
connecting, it is displayed as Not Connected.
Slave IP Address: The IP address of Slave set by Master is displayed.
Vertical, Horizontal, Run Mode, and the Trigger menu of the SETUP screen in
Sync-Master mode are as same as AWG mode, and the same setting value is used.
The Connect bottom menu performs a setup about synchronous operation.
Sync-Master mode are as same as AWG mode, and the same setting value is used.
The Connect bottom menu performs a setup about synchronous operation.
On the SETUP screen in Sync-Slave mode, only Waveform/Sequence and the
Vertical menu are effective. The setting item of Horizontal, Run Mode, and Trigger
menu is controlled from Master.
Vertical menu are effective. The setting item of Horizontal, Run Mode, and Trigger
menu is controlled from Master.
Synchronous Operation mode Sync-Master screen
Synchronous Operation mode Sync-Slave screen