Emerson 16E09-101 Installation Instruction
2
Fig. 1 Control Front View and Description
Fig. 2 Control Dimensions and Mounting Information
FRONT VIEW
BOTTOM VIEW
RIGHT SIDE VIEW
REAR VIEW
6.73”
2.8”
.76”
5.59”
.85”
2.54”
1.54”
2.91”
4.19”
1.58”
LEFT SIDE VIEW
.85”
5.59”
The control has a user selection for changing the setpoint to
be either the Cut In or the Cut Out setting. The user must be
careful to understand how this effects the “range” in which
the control will operate when the differential value is entered.
If entered values are incorrect, the control could operate
outside the user’s intended settings due to set-up error. See
section titled "Operation".
be either the Cut In or the Cut Out setting. The user must be
careful to understand how this effects the “range” in which
the control will operate when the differential value is entered.
If entered values are incorrect, the control could operate
outside the user’s intended settings due to set-up error. See
section titled "Operation".
COOL
HEAT
SW1
COOL
HEAT
SW1
Circuit Board
Inside Cover
TEMPERATURE UNITS INDICATOR (°F or °C)
ACTUAL TEMPERTURE
AT TEMPERATURE SENSOR
AT TEMPERATURE SENSOR
SETPOINT TEMPERATURE
HEATING MODE INDICATOR ( )
COOLING MODE INDICATOR ( )
BINARY INPUT INDICATOR
LIT WHEN UNIT IS IN
“SETBACK” MODE
REFER TO PAGE 6
LIT WHEN UNIT IS IN
“SETBACK” MODE
REFER TO PAGE 6
STATUS INDICATOR LED
LIT WHEN CONTROLLED LOAD
IS ENERGIZED (ON).
(SEE NOTE)
LIT WHEN CONTROLLED LOAD
IS ENERGIZED (ON).
(SEE NOTE)
TEMPERATURE “UP” BUTTON
TEMPERATURE “DOWN” BUTTON
MENU BUTTON
PRESS TO ENTER MENU MODE
REFER TO PAGES 4 & 5
PRESS TO ENTER MENU MODE
REFER TO PAGES 4 & 5
SW1
Refrigeration
Cool
Heating
Heat
Switch SW1 must be set for
system mode as shown:
system mode as shown:
To prevent electrical shock and/or equipment dam-
age, disconnect electric power to system at main
fuse or circuit breaker box prior to installation or
service.
age, disconnect electric power to system at main
fuse or circuit breaker box prior to installation or
service.
Where failure of this control may result in personal
injury and/or property damage, additional alarms or
limit controls must be installed.
injury and/or property damage, additional alarms or
limit controls must be installed.
This control is a temperature control and is not to
be used as a temperature limit control.
be used as a temperature limit control.
INSTALLATION
NOTE:
Green Status Indicator LED and display backlight operation
It may be observed from time to time that the green status indicator LED and
display back-light will briefly turn off during a call for heating or cooling. During this
time, the control is performing a self-check lasting up to 15 seconds. This is normal
operation of the control and the load power will be maintained
Green Status Indicator LED and display backlight operation
It may be observed from time to time that the green status indicator LED and
display back-light will briefly turn off during a call for heating or cooling. During this
time, the control is performing a self-check lasting up to 15 seconds. This is normal
operation of the control and the load power will be maintained