Pelco c519m-d User Manual

Pelco Manual C519M-D (7/00)

[ 9 ]

PROGRAMMING AND OPERATION

Table D. Keyboard Functions

Circled numbers refer to Figure 5.

Function

Procedure

Select Monitor*

LED display

shows monitor number in run mode.

Enter monitor number (1-4)

and press MON

to select.

NOTE: To view and control cameras on a monitor other than the one on the
keyboard, enter the number of that monitor.

Select Camera

Enter camera number (1-16)

and press CAM

to select.

NOTE: The CM6700 can be programmed to restrict some monitors from view-
ing certain cameras. To display a camera’s view on your monitor, be sure that
your keyboard shows the number of the monitor you are viewing and be sure
that the CM6700 has not been programmed to restrict viewing of that camera.

Pan/Tilt/Zoom

Move the joystick

until the camera reaches the desired position. To in-

crease the speed of movement, move the joystick further from center. Twist
the joystick clockwise to zoom in, counterclockwise to zoom out.

Lens Control

Focus, iris - Press and hold the appropriate lens control key

until the de-

sired effect is seen.

Presets

Enter preset number (1-66)

and press PRESET

to put camera in

preset position.
To program, position camera, enter desired preset number (1-66)

, and

hold down PRESET

for two seconds.

In CM6700 mode, a label appears on the monitor. Use F1 and F2

to edit

the label, then select SET and press ACK

Patterns

Programming and operation varies with the receiver type.
Spectra

domes (before version 3.0) can use one long (1 minute) or two

short (0.5 minute) patterns. Spectra domes (version 3.0), Spectra II

™

domes and Esprit™ Integrated Positioning Systems can use one long
(1.5, 3 or 6 minutes) or two short (0.75, 1.5 or 3 minutes) patterns. (Select
pattern lengths at the positioning system’s menu.)
To program Spectra and Esprit, select a camera (1-16)

, select a long

pattern by holding down PATTERN

for two seconds, or select short pat-

tern 1 or 2 by entering 1 or 2

and holding down PATTERN

for two

seconds. The monitor will indicate the programming function is active. Move
the camera position

as desired for the pattern and press ACK

close the programming function.
To run a long pattern, press PATTERN

. To run a short pattern, enter 1 or

and press PATTERN

. Move the joystick

or call a preset

to stop.
Direct Mode is the same as above, except:
Do not program a pattern with turbo pan on (switch 6).

*This function is not used in Direct Mode.

Continued on next page