Pelco c519m-d Manuel D’Utilisation
Pelco Manual C519M-D (7/00)
[ 9 ]
PROGRAMMING AND OPERATION
Table D. Keyboard Functions
Circled numbers refer to Figure 5.
Function
Procedure
Select Monitor*
LED display
1
shows monitor number in run mode.
Enter monitor number (1-4)
15
and press MON
17
to select.
NOTE: To view and control cameras on a monitor other than the one on the
keyboard, enter the number of that monitor.
keyboard, enter the number of that monitor.
Select Camera
Enter camera number (1-16)
15
and press CAM
14
to select.
NOTE: The CM6700 can be programmed to restrict some monitors from view-
ing certain cameras. To display a camera’s view on your monitor, be sure that
your keyboard shows the number of the monitor you are viewing and be sure
that the CM6700 has not been programmed to restrict viewing of that camera.
ing certain cameras. To display a camera’s view on your monitor, be sure that
your keyboard shows the number of the monitor you are viewing and be sure
that the CM6700 has not been programmed to restrict viewing of that camera.
Pan/Tilt/Zoom
Move the joystick
12
until the camera reaches the desired position. To in-
crease the speed of movement, move the joystick further from center. Twist
the joystick clockwise to zoom in, counterclockwise to zoom out.
the joystick clockwise to zoom in, counterclockwise to zoom out.
Lens Control
Focus, iris - Press and hold the appropriate lens control key
11
until the de-
sired effect is seen.
Presets
Enter preset number (1-66)
15
and press PRESET
9
to put camera in
preset position.
To program, position camera, enter desired preset number (1-66)
To program, position camera, enter desired preset number (1-66)
15
, and
hold down PRESET
9
for two seconds.
In CM6700 mode, a label appears on the monitor. Use F1 and F2
5
to edit
the label, then select SET and press ACK
16
.
Patterns
Programming and operation varies with the receiver type.
Spectra
Spectra
®
domes (before version 3.0) can use one long (1 minute) or two
short (0.5 minute) patterns. Spectra domes (version 3.0), Spectra II
™
domes and Esprit™ Integrated Positioning Systems can use one long
(1.5, 3 or 6 minutes) or two short (0.75, 1.5 or 3 minutes) patterns. (Select
pattern lengths at the positioning system’s menu.)
To program Spectra and Esprit, select a camera (1-16)
(1.5, 3 or 6 minutes) or two short (0.75, 1.5 or 3 minutes) patterns. (Select
pattern lengths at the positioning system’s menu.)
To program Spectra and Esprit, select a camera (1-16)
15
, select a long
pattern by holding down PATTERN
10
for two seconds, or select short pat-
tern 1 or 2 by entering 1 or 2
15
and holding down PATTERN
10
for two
seconds. The monitor will indicate the programming function is active. Move
the camera position
the camera position
12
as desired for the pattern and press ACK
16
to
close the programming function.
To run a long pattern, press PATTERN
To run a long pattern, press PATTERN
10
. To run a short pattern, enter 1 or
2
15
and press PATTERN
10
. Move the joystick
12
or call a preset
9
to stop.
Direct Mode is the same as above, except:
Do not program a pattern with turbo pan on (switch 6).
Direct Mode is the same as above, except:
Do not program a pattern with turbo pan on (switch 6).
*This function is not used in Direct Mode.
Continued on next page