Sennheiser EM 3731-II User Manual
21
Using the receiver
To monitor the audio signal of one of the two receivers of a twin receiver:
왘
Press the headphone button
0
of the receiver whose audio signal you
want to monitor.
To simultaneously monitor the audio signals of both receivers of a twin
receiver:
receiver:
왘
Simultaneously press the headphone buttons
0
of both receivers.
The audio signal of the left receiver is output via the left headphone
channel, the audio signal of the right receiver is output via the right
headphone channel.
channel, the audio signal of the right receiver is output via the right
headphone channel.
왘
Gradually increase the volume.
To switch the headphone output off:
왘
Press the headphone button
0
of the receiver whose headphone
output you want to switch off.
Deactivating the lock mode
When the receivers are remote controlled via a PC and the “Wireless
Systems Manager” software, their buttons can be locked via the “Wireless
Systems Manager” software. To deactivate the lock mode:
Systems Manager” software, their buttons can be locked via the “Wireless
Systems Manager” software. To deactivate the lock mode:
왘
Press the
esc
button
until the progress bar is complete and the
status display appears.
The lock mode is deactivated and the settings can be made manually.
The lock mode is deactivated and the settings can be made manually.
Synchronizing a transmitter with the receiver frequency
Via its infra-red interface, the receiver can transfer the frequency and the
name to suitable transmitters (e.g. SK 5212-II, SKM 5200-II, SK 5212,
SKM 5200 or SKP 3000).
name to suitable transmitters (e.g. SK 5212-II, SKM 5200-II, SK 5212,
SKM 5200 or SKP 3000).
왘
Set the receiver to the desired receiving frequency (see “Setting the
receiving frequency” on page 30, “Selecting a frequency bank and a
channel” on page 30) and enter the desired name (see “Entering a
name” on page 31).
receiving frequency” on page 30, “Selecting a frequency bank and a
channel” on page 30) and enter the desired name (see “Entering a
name” on page 31).
왘
Press the
sync
button
The two blue LEDs in the infra-red interface (sync)
flash and the
backlighting of the
sync
button
flashes red. The receiver is ready for
synchronization.
esc
s
ave
syn
c
300
100
100
30
10
10
10
50
100
PEAK
µV
RF
% DEV
M
H
z
776.000
01.01
BANK
CH
CH
A
B
COM
AF
0
6
Hold esc to unlock
The transmitter must be from a compatible frequency range and be
equipped with the same compander system (HDP, see page 42) as
the receiver.
equipped with the same compander system (HDP, see page 42) as
the receiver.
esc
s
ave
syn
c
digital audio
processing
syn
c
EV
M
H
z
776.000
01.01
BANK
CH
CH
COM
AF
9
A
The
sync
button
can also be used for the sorting function of the
“Wireless Systems Manager” software. For more information, refer
to page 23.
to page 23.