Graco 3A1214B User Manual
Operation
20
3A1214B
Air System Pressure Relief
1.
Relieve air pressure in air tank by turning air valve to
OPEN position.
OPEN position.
EMERGENCY SHUT OFF
To shut down the entire RoadLazer system, set POWER
ON/OFF on the Programmable Skipline Controller to the
OFF position.
ON/OFF on the Programmable Skipline Controller to the
OFF position.
Load Reflecting Materials
1.
Set POWER ON/OFF on Programmable Skipline
Controller to OFF.
Controller to OFF.
2.
Set RoadLazer engine ignition key to OFF.
3.
Relieve air system pressure by opening ball valve
until gauge reads 0.
until gauge reads 0.
4.
Relieve air pressure in bead tank by turning bead
system valve to OFF position.
system valve to OFF position.
5.
Remove cover from bead tank.
6.
Screen reflective materials to prevent debris from
entering tank.
entering tank.
7.
Load bead tank with reflective materials.
Set Up Slide Beam and Gun Arm
1.
Unlock gun arm clamp and slide beam clamps.
2.
Pull slide beam to left or right side of vehicle. Lock
slide beam clamps.
slide beam clamps.
3.
Remove gun arm from upright stowed position, and
slide to end of boom. Slowly lower gun arm, and
lock into position with clamp.
slide to end of boom. Slowly lower gun arm, and
lock into position with clamp.
Prepare System to Paint
Initial Settings
1.
Ground RoadLazer ground strap to earth ground.
2.
Fill throat packing nut with TSL to prevent premature
packing wear. Do this each time you spray and
store.
packing wear. Do this each time you spray and
store.
ti16961a
ti16425a
ti16423a
TI3058A
Approximate
Fill Level
ti5240a