Bosch FMR-1000-RCMD User Manual

Remote Command Center

 Operating | en

Bosch Security Systems, Inc.

Installation and Operation Guide

F.01U.078.098 | 3.0 | 2011.11

LED Operation

The FMR-1000-RCMD Remote Command Center uses an 80-character (4 lines x 20 characters) 

wide viewing-angle LCD display. The display includes a long-life LED backlight. The backlight 

is controlled by the panel, or locally turned on upon any key press and turned off after 

30-second time-out without key press. Even when AC power is lost, the LED backlight remains 

lit if a user is operating the keypad.

The FMR-1000-RCMD Remote Command Center has a piezo that provides audible indication 

of the system status. Refer to Table 9.2 for piezo modes when FMR-1000-RCMD is controlled 

by the panel:

Piezo Operation with FMR-1000-RCMD Panel Controlled

In case of multiple piezo activation, the system status with highest priority is indicated.

If the Remote Command Center is not controlled by the panel or during a communication 

fault, refer to Table 9.3 for piezo modes:

Piezo Operation with FMR-1000-RCMD Controlled Locally

Trouble

Yellow

On

–

When the panel is initializing

–

When the panel registers a trouble condition from a point, or the panel

–

When inputs or outputs or other elements are bypassed

Flashing 

1)

–

When the panel is not operating

–

When walk test is in progress

Off

–

When no trouble condition exists

–

When the panel is resetting

1)

 LED flash rate is 1 Hz (0.5 s on, 0.5 s off).

Silent

The panel is in a normal state (no alarm, supervisory or trouble 

condition). The panel was silenced or acknowledged after an off-

normal condition.

Continuous beep

The panel is in fire alarm condition.

Periodic beep 

(0.5 s every 2 s)

The panel is in gas alarm condition.

Periodic beep 

(0.5 s every 4 s)

The panel is in supervisory condition.

Periodic beep 

(0.5 s every 10 s)

The panel is in trouble condition or a communication fault exists 

on the Option Bus.

Short beep

With every valid key press.

Periodic beep 

(0.5 s every 10 s)

A communication fault exists on the Option Bus.