Bosch FMR-1000-RCMD User Manual

Remote Command Center

 Troubleshooting | en

Bosch Security Systems, Inc.

Installation and Operation Guide

F.01U.078.098 | 3.0 | 2011.11

pattern, or they fully de-energize, as defined by the global option “Silence Config”. Strobes 

continue flashing.

If programmed, the panel transmits a silence report to the central station.

If the panel is already silenced, pressing [SILENCE] again causes an unsilence command in the 

panel. Silence operation does not reset the alarm status and does not return the activated 

input to normal service. Any new alarm reactivates any silenced outputs.

If any events are not cleared within 24 hours after the [SILENCE] or [ACK] key was pressed, 

the panel turns on the piezo again and events are transmitted to the central station again.

Pressing the reset key turns off the piezo and all activated or silenced outputs. The reset 

operation  turns off auxiliary power AUX/RST for 5 seconds, and activates the global resetting 

zone. All alarms, supervisories, and troubles caused by activation of SLC points are cleared. 

Then the panel tries to reset all points that are in off-normal status. Not all system trouble 

conditions are affected by the reset operation. If programmed, the panel transmits a reset 

report to the central station.

Any alarm or trouble that exists after a reset causes the system to sound again.

To activate the drill operation, the [DRILL] key must be pressed twice to prevent accidental 

activation. Pressing the key once the system prompts for confirmation. Pressing the [DRILL] 

key again turns on all unbypassed NACs and drillable relay outputs.

The drill operation stops if the reset key is pressed, or it is automatically cancelled if the 

operation was started for a programmed time. A system reset is automatically performed by 

stopping the drill so that the panel and all field devices restore to their normal operation.

If programmed, a drill start report and a drill stop report are transmitted to the central 

station.

NOT PROGRAMMED

0.5 s on/

0.5 s off

0.5 s every 

10 s

No communication activities on 

the device address.

NO COMMUNICATION

0.5 s on/

0.5 s off

0.5 s every 

10 s

After 60 seconds of no 

communication activities on any 

Option Bus address.

COMMUNICATION OK

off

off

Communication on the device 

address; no text received yet.

Operating voltage

Nominal 12 V DC or 24 V DC/FWR

Current consumption at 12 V DC

–

Standby current

25 mA maximum (only Power LED on)

–

Alarm current

150 mA maximum (with annunciator lit and piezo 

on)