Philips DVP3264/12 User Manual

41

–  Press STANDBY-ON on the unit to turn on the 

power.

–  Ensure that the AC outlet has power.
–  Disconnect the power cord from the power outlet 

for a few minutes. Reconnect the power cord and try 
to operate again as usual.

–  Refer to your TVs manual for correct Video In 

channel  selection. Change the TV channel until you 
see the DVD screen.

–  If this happens when you turn on the progressive scan 

feature, wait for 15 seconds for the auto recovery or 
switch back to the default mode as below:

1) Press ç  on  this  unit.
2) Press and hold numeric keypad ‘1’ on the remote 

control. 

–  If this happens after you set the colour system, wait 

for 15 seconds for the auto recovery or switch back 
to the default TV colour system:

1) Press ç   on  this  unit.
2) Press and hold numeric keypad ‘3’ on the remote 

control. 

–  Check the video connection.
–  Ensure that the disc is compatible with this unit.
–  Sometimes a small amount of picture distortion may  

 appear. This is not a malfunction.

–  The disc is dirty. Clean the disc.

–  Check the audio connections to the connected audio 

device.  

–  Make sure that the connected audio device is turned 

on to the correct input source.

–  Set the digital output setting correctly, based on the 

device you connected to this unit. See ‘Audio Setup 
Page – Digital Audio Setup’ for details.

WARNING
Under no circumstances should you try to repair this unit yourself, as this invalidates the 
warranty. Do not open this unit as there is a risk of electric shock.

If a fault occurs, fi rst check the points listed below before taking this unit for repair. If you 
are unable to remedy a problem by following these hints, consult your dealer or Philips for 
help.

1dvp3260_3264_eu_eng1.indd   41

1dvp3260_3264_eu_eng1.indd   41

2008-03-10   4:37:44 PM

2008-03-10   4:37:44 PM