Bosch ltc-0335-28 Installation Instruction

106 en | Devices page

Bosch Video Management System

Configuration Client | V3 | 2010.07

Configuration Manual

Bosch Sicherheitssysteme GmbH

Main window > 

 Devices > Expand 

 > 

Allows you to activate the Bosch Allegiant CCL emulation. This emulation starts an internal 

Bosch VMS service that translates CCL commands of the Matrix Switch into Bosch VMS. You 

configure a COM port of the Central Server to listen to these CCL commands. The CCL 

emulation helps to exchange existing Allegiant devices with Bosch Video Management System 

or to use Bosch Video Management System with applications that support the Allegiant CCL 

commands.

Do not configure the Allegiant CCL emulation and an Allegiant device to the same COM port. If 

for both devices the same COM port is configured, the Allegiant device wins. The access of 

the Allegiant CCL emulation device fails with an appropriate message. 

To solve this, the Central Server must have two different COM ports or connect the Allegiant 

device to another computer.

Select the check box to enable the emulation.

Select the value for the transmission rate in bit/s.

Select the number of stop bits per character. 

Select the type of parity check.

Select the desired protocol for the serial interface.

Select the setting appropriate for your application.

Main window > 

 Devices > Expand 

 > 

Allows you to add and configure VRM devices. A VRM device needs at least an encoder, an 

iSCSI device, and a LUN assigned to the iSCSI device. See the Release Notes and the data 

sheet for current firmware versions. The recording mode of the assigned encoders is set to 

VRM when the configuration is activated.

After you have added an iSCSI device with respective encoders to your Bosch Video 

Management System, you must add the IQN of each encoder to this iSCSI device.

See Section 6.22 Configuring an iSCSI device, page 33 for details.