Bosch ltc-0335-28 Installation Instruction

Bosch Video Management System

 Encoders / Decoders page | en

Bosch Sicherheitssysteme GmbH

Configuration Manual

Configuration Client | V3 | 2010.07

Select the default image layout for the monitor.

Type the aspect ratio of the screen (e.g. 4 x 3) or the physical size of the screen in millimeters. 

The device uses this information to accurately scale the video image for distortion-free 

display.

The device recognizes transmission interruptions and displays a warning on the monitor.

Select On to display a warning in case of transmission interruption.

Move the slider to adjust the level of the interruption that triggers the warning.

Type the text of the warning the monitor displays when connection is lost. The maximum text 

length is 31 characters.

Click to delete the logo that has been configured on the Web page of the decoder.

This function allows you to configure the switching behavior of the relay outputs.

You can configure the switching behavior of the relay outputs. For each relay, you can specify 

an open switch relay (normally closed contact) or a closed switch relay (normally open 

contact).

You can also specify whether an output should operate as a bistable or monostable relay. In 

bistable mode, the triggered state of the relay is maintained. In monostable mode, you can set 

the time after which the relay returns to the idle state. 

You can select different events that automatically activate an output. It is possible, for 

example, to turn on a floodlight by triggering a motion alarm and then turning the light off 

again when the alarm has stopped. 

Select Open if you want the relay to operate as an NO contact, or select Closed if the relay is 

to operate as an NC contact. 

Select an operating mode for the relay.

For example, if you want an alarm-activated lamp to stay on after the alarm ends, select the 

Bistable entry. If you wish an alarm-activated siren to sound for ten seconds, select the 10 s 

entry.

If required, select a specific event that will trigger the relay. The following events are possible 

triggers:

Off: Relay is not triggered by events 

Connection: Trigger whenever a connection is made 

Video alarm: Trigger by interruption of the video signal at the corresponding input