Bosch ltc-0335-28 Installation Instruction

122 en | Encoders / Decoders page

Bosch Video Management System

Configuration Client | V3 | 2010.07

Configuration Manual

Bosch Sicherheitssysteme GmbH

Motion alarm: Trigger by motion alarm at the corresponding input, as configured on the VCA 

page.

Local input: Trigger by the corresponding external alarm input 

Remote input: Trigger by remote station's corresponding switching contact (only if a 

connection exists) 

The numbers in the lists of selectable events relate to the corresponding connections on the 

device, Video alarm 1, for example to the Video In 1 connection. 

Click the relay button to trigger the relay manually (for example, for testing purposes or to 

activate a door opener).

Displays the state of each relay. 

Red: Relay is activated.

Blue: Relay is not activated.

This function allows you to configure the serial interface parameters according to your 

requirements.

If the device is working in multicast mode, the first remote location to establish a video 

connection to the device is also assigned the transparent data connection. However, after 

about 15 seconds of inactivity the data connection is automatically terminated and another 

remote location can exchange transparent data with the device.

Select a controllable device from the list. Select Transparent data to transmit transparent 

data via the serial port. Select Terminal to operate the device from a terminal.

After selecting a device, the remaining parameters in the window are set automatically and 

should not be changed.

Select the value for the transmission rate.

Select the number of stop bits per character.

Select the type of parity check.

Select the protocol for the serial interface.

The settings on this page are used to integrate the device into an existing network.

After changing the Subnet mask and/or the Gateway address, restart the computer.