Bosch ltc-0335-28 Installation Instruction

124 en | Encoders / Decoders page

Bosch Video Management System

Configuration Client | V3 | 2010.07

Configuration Manual

Bosch Sicherheitssysteme GmbH

The maximum segment size for a connection to the iSCSI system can be higher than for the 

other data traffic via the network. The size depends on the network structure. A higher value 

is only useful if the iSCSI system is located in the same subnet as the device.

Allows you to use the Dynamic DNS network service, provided that a DynDNS.org account 

exists and the registration of the host name of the device.

Select On to enable Dynamic DNS.

Type the host name. Use the host name listed in DynDNS.org.

Type the user name. Use the user name listed in DynDNS.org.

Type the password. Use the password listed in DynDNS.org.

Displays the status of the DynDNS function.

The device supports the SNMP V2 (Simple Network Management Protocol) for managing and 

monitoring network components, and can send SNMP messages (traps) to IP addresses. The 

device supports SNMP MIB II in the unified code.

Select On to activate the SNMP function.

Type the IP addresses of one or two target units. The device (e.g. encoder, camera) sends 

SNMP traps automatically to the target units.

If you do not enter IP addresses, the device only replies to SNMP requests and does not send 

SNMP traps to the target units.

Allows you to select which traps the device sends to the target units. To do this, click Select.

Click Select. The SNMP traps dialog box is displayed.

Select the check boxes of the appropriate traps, and then click OK.

IEEE 802.1x allows you to communicate with the device if a RADIUS server is used in a 

network.

Select On to activate 802.1x.

Type the user name that the RADIUS server uses for identifying the device.