Bosch ltc-0335-28 Installation Instruction

134 en | Cameras and Recording page

Bosch Video Management System

Configuration Client | V3 | 2010.07

Configuration Manual

Bosch Sicherheitssysteme GmbH

Displays the type of firmware used in the encoder.

Displays the name of the camera.

Displays the IP address of the camera.

Displays the location of the camera. If the camera is not assigned to a location yet, 

Unassigned Location is displayed.

Click a cell to select the live quality for a VRM or a local storage / live only encoder of stream 2.

Click a cell to edit the logical number that the camera received automatically when it was 

detected. If you enter an already used number, a corresponding error message is displayed.

The logical number is "free" again when the camera is removed.

Click a cell to assign an audio source to the camera. Only for NVR recording: You can assign 

one audio source to multiple cameras. 

If an alarm occurs with low priority and with a camera that has audio configured, this audio 

signal is played even when an alarm with higher priority is currently being displayed. But this 

is only true, if the high priority alarm has no audio configured.

 (Only visible when you click 

 All)

Select a check box to activate PTZ control.

For port settings refer to Section 18.12.1 COM1, page 122.

Protocol (Only visible when you click 

 All)

Click a cell to select the appropriate protocol for the PTZ control.

Dome Address (Only visible when you click 

 All)

Type the address number for the PTZ control.

Click a cell to edit the minimum number of days that video data from this camera is retained. 

Recordings younger than this number of days are not deleted automatically.

Click a cell to edit the maximum number of days that video data from this camera is retained. 

Only recordings older than this number of days are deleted automatically.