Bosch ltc-0335-28 Installation Instruction
Bosch Video Management System
Configuring devices | en
27
Bosch Sicherheitssysteme GmbH
Configuration Manual
Configuration Client | V3 | 2010.07
3.
Ensure that the following settings are applied:
–
Serial port function: Transparent
–
Baud rate: 19200
–
Stop bits: 1
–
Parity check: None
–
Interface mode: RS232
–
Half-duplex mode: Off
6.6
Configuring multiple encoders / decoders
Main window
You can modify the following properties of multiple encoders and decoders at once:
–
Display names
–
IP addresses
–
Firmware versions
To configure multiple IP addresses:
1.
On the Hardware menu, click IP Device Configuration....
The IP Device Configuration dialog box is displayed.
2.
Select the required devices.
You can select multiple devices by pressing the CTRL- or the SHIFT-key.
3.
Right-click the selected devices and click Set IP Addresses....
The Set IP Addresses dialog box is displayed.
4.
In the Start with: field, type the first IP address.
5.
Click Calculate.
In the End with: field, the last IP address of the range for the selected devices is
displayed.
6.
Click OK.
7.
In the IP Device Configuration... dialog box, click Apply.
The new IP addresses are updated in the selected devices.
To configure multiple display names:
1.
On the Hardware menu, click IP Device Configuration....
The IP Device Configuration dialog box is displayed.
2.
Select the required devices.
Multiple selection is possible by pressing the SHIFT key.
3.
Right-click the selected devices and click Set Display Names...
The Set Display Names dialog box is displayed.
4.
In the Start with: field, type the first string.
5.
Click Calculate.
In the End with: field, the last string of the range for the selected devices is displayed.
6.
Click OK.
7.
In the IP Device Configuration... dialog box, click Apply.
The calculated names are updated in the selected devices.
To update firmware for multiple devices:
1.
On the Hardware menu, click IP Device Configuration....
The IP Device Configuration dialog box is displayed.
NOTICE!
Changing the IP address of an IP device can make it unreachable.