Manualsbrain.com
  1. Manuals
  2. Brands
  3. Bosch
  4. ltc-0335-28
  5. Installation Instruction

Bosch ltc-0335-28 Installation Instruction

Download
Page of 188
98
en | Devices page
Bosch Video Management System
Configuration Client | V3 | 2010.07
Configuration Manual
Bosch Sicherheitssysteme GmbH
–
When the decoder is switched to single view or to quad view and a sequence is just 
running, only the last video stream remains visible.
–
When the user switches to quad view, the last cameras that have been displayed on tile 
2-4 are reconnected.
–
This  also  valid  for  trunklines. There is only one limitation: If the matrix camera cannot be 
reconnected, this is ignored without an error message. A black tile is visible.
–
When switching to single view, all trunklines that are displayed on tile 2-4 are 
disconnected. Only the camera number is stored for a later switch to quad view.
Decoder Name
Displays the display name of the decoder.
Network Address
Displays the IP address of the decoder.
Logical Number
Enter the logical number of the decoder. If you enter an already used number, a message is 
displayed.
Quad
Displays the position of the decoder on the quad view. 1 is left upper corner, 4 is right lower 
corner.
Quad View
Select the check box to enable quad view for this decoder. On the Settings page, the 
corresponding analog monitor image displays the quad view. Logical numbers are created 
automatically. If you want the Operator Client user to be able to switch between quad view 
and single view, then check Quad View. If you clear Quad View, the Operator Client user 
cannot switch.
AMG
Displays the analog monitor group that the decoder in this row is assigned to.
Initial Camera
Click to select the camera that is displayed initially on the monitor after having started the 
Operator Client. The logical number of the initial camera is displayed as the white number on 
the monitor image in the Settings page.
OSD Camera Name
Check to display the camera name as OSD.
OSD Camera No.
Check to display the logical number of the camera as OSD.
OSD Position
To set the location of an OSD, select the desired entry.
17.15
Communication Devices page
Main window > 
 Devices > Expand 
 > 
Allows you to add or configure a communication device.
You can configure the following communication devices:
–
E-mail
–