TallyGenicom 2440 User Guide
Paper handling
Operating the printer
2-22
Single sheets
1
Move the paper select lever back-ward
to Single Sheet position.
to Single Sheet position.
2
If necessary, readjust the Print Gap
lever for continuous forms (see section
“Print Gap Lever” on page 2-19).
lever for continuous forms (see section
“Print Gap Lever” on page 2-19).
3
Make sure that the printer is turned on.
4.
Raise the single sheet feeder until it
locks into its mounting.
locks into its mounting.
5.
Align the left paper guide with the mark
on the left of the single sheet feeder.
Adjust the right paper guide to the
width of the paper used.
on the left of the single sheet feeder.
Adjust the right paper guide to the
width of the paper used.
6.
Insert a sheet of paper. Make sure that
the bottom edge of the paper engages
snugly with the platen. The paper will
automatically advance to the top-of-
form posi-tion if the Single Sheet Load
option of the Setup mode is set to
Automatic.
the bottom edge of the paper engages
snugly with the platen. The paper will
automatically advance to the top-of-
form posi-tion if the Single Sheet Load
option of the Setup mode is set to
Automatic.
The factory setting for the Single Sheet
Load option is automatic loading after pa-
per detection. If you set this option to man-
ual, you will have to press FF/LOAD to
feed the paper.
Load option is automatic loading after pa-
per detection. If you set this option to man-
ual, you will have to press FF/LOAD to
feed the paper.