Sennheiser EM 2000 User Guide

Using the receiver

14

Using the receiver

To establish a transmission link, proceed as follows:

1.

Switch the receiver on (see next section).

2.

Switch the transmitter on (see the instruction manual of the transmitter).
The transmission link is established and the display backlighting of the receiver changes
from red to orange.

If you cannot establish a transmission link between transmitter and receiver, read the
chapter “Synchronizing transmitters with receivers” on page 31.

Switching the receiver on/off

To switch the receiver 

on

:

To switch the receiver to 

standby mode

:

To 

completely

 switch the receiver 

off

:

왘

If necessary, deactivate the lock mode (see page 15).

왘

Disconnect the receiver from the mains by unplugging the mains cable plug from the wall
socket.
The backlighting of the 

STANDBY 

button

 goes off.

Monitoring the audio signal via headphones

왘

Set the headphone volume control

 to the minimum position.

왘

Connect headphones with a ¼” (6.3 mm) stereo jack plug to the headphone output

왘

Gradually increase the volume and monitor the audio signal with the lowest possible
volume.

It is vital to observe the notes on frequency selection on page 31.

 MHz

**2000**

쐊

왘

Briefly press the 

STANDBY

 button

The receiver switches on and the “

Receiver Parameters

” standard display

appears.

왘

Keep the 

STANDBY

 button

 pressed until “

OFF

” appears on the display panel.

The receiver switches to standby mode. The integrated antenna splitter and the
booster supply voltage remain active so that the antenna signals are still looped
through to daisy-chained receivers.

• When in the operating menu, pressing the 

STANDBY 

button 

 will cancel your

entry (ESC function) and return you to the current standard display.

• The 

STANDBY

 button 

 is backlit in red both during operation and in standby

mode.

CAUTION!

Danger of hearing damage!

Listening at high volume levels for long periods can lead to permanent hearing defects.

왘

Set the headphone volume control

 to the minimum position before putting the head-

phones on.

B.Ch: 

쐇 쐋