Sennheiser EM 2000 User Guide
Using the receiver
15
Synchronizing a transmitter with the receiver
You can synchronize a suitable transmitter of the 2000 series with the receiver. By default,
the following parameters are transferred to the transmitter during synchronization:
the following parameters are transferred to the transmitter during synchronization:
To transfer the parameters:
왘
Switch the transmitter and the receiver on.
왘
Press the
button
on the receiver.
“
Sync
” appears on the display panel of the receiver.
왘
Place the infra-red interface of the transmitter (see the instruction manual of the trans-
mitter) in front of the infra-red interface
mitter) in front of the infra-red interface
of the receiver.
The parameters are transferred to the transmitter. When the transfer is completed, “
”
appears on the receiver’s display panel. The receiver then switches back to the current
standard display.
standard display.
To cancel the transfer:
왘
Press the
STANDBY
button
on the receiver.
“ ” appears on the display panel of the receiver. “ ” also appears if no suitable trans-
mitter was found.
mitter was found.
Deactivating the lock mode temporarily
You can activate or deactivate the automatic lock mode via the “
Auto Lock
” menu item
(see page 25).
If the lock mode is activated, you have to temporarily deactivate it in order to be able to
operate the receiver:
operate the receiver:
The lock mode icon
flashes prior to the lock mode being activated again.
Setting
Transferred parameter
“
Frequency Preset
” Currently set frequency
“
Name
”
Freely selectable name currently set on the receiver
“
Pilot Tone
”
Current pilot tone setting of the receiver (“
Inactive
”/“
Active
”)
Via the “
Sync Settings
” submenu, you can adjust additional parameters to be trans-
ferred to the transmitters (see page 29). It is vital to observe the notes on frequency
selection on page 31.
selection on page 31.
쐏 쐄
쐏 쐄
왘
Press the jog dial or the
STANDBY
button.
“
Locked
” appears on the standard display.
왘
Turn the jog dial.
“
“
Unlock?
” appears on the display panel.
왘
Press the jog dial.
The lock mode is temporarily deactivated.
The lock mode is temporarily deactivated.
– When you are in the operating menu, the lock mode remains deactivated until
you exit the operating menu.
– When one of the standard displays is shown, the lock mode is automatically
activated after 10 seconds.
543.200
B.Ch: 20.64
PEAK
MUTE
EQ:
+ 12dB
-10
0
40
30
20
10
-20
-30
-40
-30
-40
AF
RF
MHz
**2000**
SKM2000
P
햾