Bosch hdi7052u User Guide

Conversion

English 4

5. Place the new orifice into the socket then insert each orifice into its respective

threaded hole in the jet holder. Tighten until the orifice stops turning. DO NOT
OVER TIGHTEN.

6. Remove screws to replace burner base, burner cap and burner grate.

Replace screws.
Note: Burner cap must be properly positioned on burner base for burner to
light.

7. Place natural gas orifices in back of card for future conversion back to natural

gas.

Convert Cooktop Valves
for Propane Use

1. Verify that all knobs are in the OFF position
2. Remove knobs (pull straight out)
3. Insert 1/8” (or smaller) flat head screwdriver into shaft and turn bypass screw

clockwise until it stops (bypass screw is inside shaft). DO NOT OVER-
TIGHTEN.

5. Replace knobs.

If your range is dual fuel your conversion is complete. Replace the cover
plate and warming drawer and proceed to “Test the Installation” on page 6.

For gas range conversions, continue to next step.

Adjust Broil Burner Ori-
fice

1. Remove oven door (see section "Removing Oven Door" in Use and Care

manual).

2. Remove Broil Burner Assembly. The broil burner assembly is attached to the

top of the oven cavity with 7 screws. Remove screws and gently pull broil
burner assembly straight out being careful not to detach electrical wires.
Place broil burner against back wall of oven cavity.

3. Adjust Broil Orifice. The orifice is located behind the broil burner in the back

oven wall (See Figure 5). Use a 1/2" deep socket driver with 3" minimum

Figure 4: Cooktop Valve Conversion

OFF

SIM

Bypass Screw Inside Shaft