Alcatel-Lucent 6850-48 Network Guide

Configuring Static Link Aggregation

Configuring Static Link Aggregation Groups

OmniSwitch AOS Release 6 Network Configuration Guide

page 22-7

This section describes how to use Alcatel-Lucent’s Command Line Interface (CLI) commands to config-
ure static link aggregate groups. See 

 for more information.

Note. See 

 for a brief tutorial on 

configuring these mandatory parameters.

Alcatel-Lucent’s link aggregation software is preconfigured with the default values for static aggregate 
groups as shown in the table in 

. If you need to 

modify any of these parameters, please see 

 for more information.

Note. See the “Link Aggregation Commands” chapter in the OmniSwitch CLI Reference Guide for 
complete documentation of CLI commands for link aggregation.

When configuring static link aggregates on a switch you must perform the following steps:

1 Create the Static Aggregate Group on the Local and Remote Switches. To create a static aggregate 
group use the 

 command, which is described in 

2 Assign Ports on the Local and Remote Switches to the Static Aggregate Group. To assign ports to 
the static aggregate group you use the 

 command, which is described in 

Note. Depending on the needs of your network you may need to configure additional parameters. 
Commands to configure optional static aggregate parameters are described in 

.