Alcatel-Lucent 6850-48 ネットワークガイド
Configuring Static Link Aggregation
Configuring Static Link Aggregation Groups
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 22-7
Configuring Static Link Aggregation Groups
This section describes how to use Alcatel-Lucent’s Command Line Interface (CLI) commands to config-
ure static link aggregate groups. See
ure static link aggregate groups. See
for more information.
Note. See
configuring these mandatory parameters.
Alcatel-Lucent’s link aggregation software is preconfigured with the default values for static aggregate
groups as shown in the table in
groups as shown in the table in
. If you need to
modify any of these parameters, please see
for more information.
Note. See the “Link Aggregation Commands” chapter in the OmniSwitch CLI Reference Guide for
complete documentation of CLI commands for link aggregation.
complete documentation of CLI commands for link aggregation.
Configuring Mandatory Static Link Aggregate Parameters
When configuring static link aggregates on a switch you must perform the following steps:
1 Create the Static Aggregate Group on the Local and Remote Switches. To create a static aggregate
group use the
group use the
2 Assign Ports on the Local and Remote Switches to the Static Aggregate Group. To assign ports to
the static aggregate group you use the
the static aggregate group you use the
command, which is described in
Note. Depending on the needs of your network you may need to configure additional parameters.
Commands to configure optional static aggregate parameters are described in
Commands to configure optional static aggregate parameters are described in
.