Alcatel-Lucent 6850-48 Network Guide

Modifying Dynamic Link Aggregate Group Parameters

Configuring Dynamic Link Aggregation

page 23-18

OmniSwitch AOS Release 6 Network Configuration Guide

For example, to reset the partner system priority of dynamic aggregate group 4 to its default value you 
would enter:

-> lacp linkagg 4 no partner system priority

By default, the dynamic aggregate group partner system ID is 00:00:00:00:00:00. The following subsec-
tions describe how to configure a user-specified value and how to restore it to its default value with the 

You can configure the dynamic aggregate group partner system ID by entering lacp linkagg followed by 
the dynamic aggregate group number, partner system id, and the user-specified MAC address (in the 
hexadecimal format of xx:xx:xx:xx:xx:xx), which is used as the system ID.

For example, to configure the partner system ID as 00:20:da:81:d5:b0 on dynamic aggregate group 4 you 
would enter:

-> lacp linkagg 4 partner system id 00:20:da:81:d5:b0

To remove the user-configured partner switch system ID from the dynamic aggregate group’s configura-
tion, use the no form of the 

 command by entering lacp linkagg followed 

by the dynamic aggregate group number and no partner system id.

For example, to remove the user-configured partner system ID from dynamic aggregate group 4 you 
would enter:

-> lacp linkagg 4 no partner system id

This section describes how to modify the following dynamic aggregate actor port parameters:

• Actor port administrative state (see 

• Actor port system ID (see 

)

• Actor port system priority (see 

• Actor port priority (see 

Note. See 

 

for information on modifying a dynamic aggregate group administrative key.

All of the commands to modify actor port parameters allow you to add the ethernet, fastethernet, and 
gigaethernet keywords before the slot and port number to document the interface type or make the 
command look consistent with early-generation Alcatel-Lucent CLI syntax. However, these keywords do 
not modify a port’s configuration. See 

 for information on config-

uring Ethernet ports.