Alcatel-Lucent 6850-48 Guide De Réglage Du Réseau
Modifying Dynamic Link Aggregate Group Parameters
Configuring Dynamic Link Aggregation
page 23-18
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
For example, to reset the partner system priority of dynamic aggregate group 4 to its default value you
would enter:
would enter:
-> lacp linkagg 4 no partner system priority
Modifying the Dynamic Aggregate Group Partner System ID
By default, the dynamic aggregate group partner system ID is 00:00:00:00:00:00. The following subsec-
tions describe how to configure a user-specified value and how to restore it to its default value with the
tions describe how to configure a user-specified value and how to restore it to its default value with the
Configuring a Dynamic Aggregate Group Partner System ID
You can configure the dynamic aggregate group partner system ID by entering lacp linkagg followed by
the dynamic aggregate group number, partner system id, and the user-specified MAC address (in the
hexadecimal format of xx:xx:xx:xx:xx:xx), which is used as the system ID.
the dynamic aggregate group number, partner system id, and the user-specified MAC address (in the
hexadecimal format of xx:xx:xx:xx:xx:xx), which is used as the system ID.
For example, to configure the partner system ID as 00:20:da:81:d5:b0 on dynamic aggregate group 4 you
would enter:
would enter:
-> lacp linkagg 4 partner system id 00:20:da:81:d5:b0
Restoring the Dynamic Aggregate Group Partner System ID
To remove the user-configured partner switch system ID from the dynamic aggregate group’s configura-
tion, use the no form of the
tion, use the no form of the
command by entering lacp linkagg followed
by the dynamic aggregate group number and no partner system id.
For example, to remove the user-configured partner system ID from dynamic aggregate group 4 you
would enter:
would enter:
-> lacp linkagg 4 no partner system id
Modifying Dynamic Link Aggregate Actor Port Parameters
This section describes how to modify the following dynamic aggregate actor port parameters:
• Actor port administrative state (see
• Actor port system ID (see
)
• Actor port system priority (see
• Actor port priority (see
Note. See
for information on modifying a dynamic aggregate group administrative key.
All of the commands to modify actor port parameters allow you to add the ethernet, fastethernet, and
gigaethernet keywords before the slot and port number to document the interface type or make the
command look consistent with early-generation Alcatel-Lucent CLI syntax. However, these keywords do
not modify a port’s configuration. See
gigaethernet keywords before the slot and port number to document the interface type or make the
command look consistent with early-generation Alcatel-Lucent CLI syntax. However, these keywords do
not modify a port’s configuration. See
for information on config-
uring Ethernet ports.