Alcatel-Lucent 6850-48 Reference Guide
LINK OAM Commands
OmniSwitch CLI Reference Guide
September 2009
page 29-27
show efm-oam port
Displays the status of LINK OAM on all the ports in the system, along with other relevant information
such as OAM mode, operational status and loopback status of the port.
such as OAM mode, operational status and loopback status of the port.
show efm-oam port [slot/port1-port2] [enable | disable] [active | passive]
Syntax Definitions
slot/port1
The slot number for the module and the physical port number on that
module (e.g. 3/1 specifies port 1 on slot 3).
module (e.g. 3/1 specifies port 1 on slot 3).
-port2
The last port number in a range of ports that you want to configure on
the same slot (e.g. 3/1-4 specifies ports 1,2,3, and 4 on slot 3).
the same slot (e.g. 3/1-4 specifies ports 1,2,3, and 4 on slot 3).
enable
Specifies whether to display the LINK OAM enabled ports.
disable
Specifies whether to display the LINK OAM disabled ports.
active
Specifies whether to display the LINK OAM active ports.
passive
Specifies whether to display the LINK OAM passive ports.
Defaults
By default, displays the LINK OAM status on all ports.
Platforms Supported
OmniSwitch 6400, 6850, 6855.
Usage Guidelines
Use this command to display the state of LINK OAM on the basis of enabled or disabled port and on the
basis of active or passive port.
basis of active or passive port.
Examples
-> show efm-oam port
Port EFM-OAM Status Mode Operational Status Loopback Status
-------+----------------+---------+-------------------+----------------
1/1 enabled active operational remoteLoopback
1/2 disabled active activeSendLocal noLoopback
1/3 enabled passive activeSendLocal noLoopback
1/4 disabled active activeSendLocal noLoopback
1/5 disabled active activeSendLocal noLoopback
1/6 disabled active activeSendLocal noLoopback
1/7 disabled active activeSendLocal noLoopback
-> show efm-oam port 1/1-5
Port EFM-OAM Status Mode Operational Status Loopback Status
-------+----------------+---------+-------------------+----------------
1/1 enabled active operational remoteLoopback
1/2 disabled active activeSendLocal noLoopback
1/3 enabled passive activeSendLocal noLoopback