Alcatel-Lucent 6850-48 Reference Guide

LINK OAM Commands

OmniSwitch CLI Reference Guide

page 29-29

Release 6.4.2; command was introduced.

The status of  the port in discovering whether the peer has LINK OAM 
capability or not.It has the following states:

• activeSendLocal: Specifies that the LINK OAM port is 

actively trying to discover whether the peer has LINK OAM 
capability but has not yet made that determination. 

• sendLocalAndRemote: Specifies that the local LINK OAM 

port has discovered the peer but has not yet accepted or 
rejected the configuration of the peer. The local device will 
then decide that the peer device is acceptable or unacceptable 
and then accept or decline LINK OAM peering.

• sendLocalAndRemoteOk: Specifies the state when LINK 

OAM peering is allowed by the local port. 

• oamPeeringLocallyRejected: Specifies the state when the 

local OAM entity rejects the peer OAM entity.

• oamPeeringRemotelyRejected: Specifies the state when the 

remote LINK OAM port rejects the peering.

• operational: Specifies the state when the local LINK OAM 

port learns that both the local LINK OAM entity and the 
remote LINK OAM entity have accepted the peering.

• nonOperHalfDuplex: Specifies the value nonOperHalfDu-

plex is returned whenever LINK OAM is enabled. Since LINK 
OAM functions are not designed to work completely over half-
duplex interfaces, the value nonOperHalfDuplex is returned 
whenever LINK OAM is enabled but the interface is in half-
duplex operation.

• linkFault: Specifies that the link between the host and the peer 

has detected a fault. 

• passiveWait: Specifies that the LINK OAM ports are in 

passive mode. 

The state of remote loopback. It can be initiatingLoopback, terminat-
ingLoopback, localLoopback, remoteLoopback, noLoopback, or 
unknown. 

The state of LINK OAM mode, active or passive.