Alcatel-Lucent 6850-48 Reference Guide

OSPF Commands

OmniSwitch CLI Reference Guide

page 41-83

The following is an example of simple authentication (an interface name is used in this example):

-> show ip ospf interface vlan-3

Interface IP Name                     = vlan-3

VLAN Id                               = 3,

Interface IP Address                  = 100.10.10.2,

Interface IP Mask                     = 255.255.255.0,

Admin Status                          = Enabled,

Operational Status                    = Up,

OSPF Interface State                  = DR,

Interface Type                        = Broadcast,

Area Id                               = 0.0.0.2,

Designated Router IP Address          = 100.10.10.2,

Designated Router RouterId            = 192.169.1.2,

Backup Designated Router IP Address   = 0.0.0.0,

Backup Designated Router RouterId     = 0.0.0.0,

MTU  (bytes)                          = 1500,

Metric Cost                           = 1,

Priority                              = 1,

Hello Interval (seconds)              = 10,

Transit Delay (seconds)               = 1,

Retrans Interval (seconds)            = 5,

Dead Interval (seconds)               = 40,

Poll Interval (seconds)               = 120,

Link Type                             = Broadcast,

Authentication Type                   = simple,

Authentication Key                    = Set,

# of Events                           = 3,

# of Init State Neighbors             = 0,

# of Exchange State Neighbors         = 0,

# of 2-Way State Neighbors            = 0,

# of Full State Neighbors             = 0

Output fields when an interface name is specified are described below:

The name of the VLAN to which the interface is assigned. This field is 
not displayed on OmniSwitch 6800 Series switches.

The VLAN to which the interface is assigned.

The IP address assigned to the interface.

The IP mask associated with the IP address assigned to the interface.

The current administration status of the interface, either enabled or 
disabled.

Whether the interface is an active OSPF interface.

The current state of the OSPF interface. It will be down, up, dp, dr, or 
other.

The OSPF interface type, which can be Broadcast, NBMA, Point-to-
Point, or Point-to-Multipoint.

The area identification number to which the interface is assigned. This 
field is not applicable if an interface has not yet been assigned to an 
area.

Designated Router IP Address The designated router IP address.

The identification number of the designated router.