Alcatel-Lucent 6850-48 Reference Guide
PIM Commands
OmniSwitch CLI Reference Guide
September 2009
page 45-55
Release History
Release 6.1.1; command was introduced.
Release 6.3.1; sparse and dense options removed; Mode, Prune Delay Value, Prune Delay Option, CBSR
Preference fields removed; Propagation Delay, Effective Propagation Delay, Effective Override Interval,
Suppression Enabled, DR Priority Enabled, and Stub Interface fields added.
Release 6.3.1; sparse and dense options removed; Mode, Prune Delay Value, Prune Delay Option, CBSR
Preference fields removed; Propagation Delay, Effective Propagation Delay, Effective Override Interval,
Suppression Enabled, DR Priority Enabled, and Stub Interface fields added.
Related Commands
MIB Objects
alaPimInterfaceTable
alaPimInterfaceIfIndex
alaPimInterfaceDR
alaPimInterfaceHelloInterval
alaPimInterfaceJoinPruneInterval
alaPimInterfaceStatus
alaPimInterfaceAddress
alaPimInterfaceTrigHelloInterval
alaPimInterfaceHelloHoldtime
alaPimInterfaceJoinPruneHoldtime
alaPimInterfacePropagationDelay
alaPimInterfaceOverrideInterval
alaPimInterfaceGenerationIDValue
alaPimInterfaceDRPriority
alaPimInterfaceLanDelayEnabled
Effective Override Interval
The Effective Override Interval on this interface.
Suppression Enabled
Specifies whether the Join suppression is enabled on this interface.
DR Priority Enabled
Evaluates to TRUE if all routers on this interface are using the DR Pri-
ority option.
ority option.
Stub Interface
Specifies whether this interface is a 'stub interface'. If this is TRUE,
then no PIM packets are sent out on this interface, and any received
PIM packets are ignored.
then no PIM packets are sent out on this interface, and any received
PIM packets are ignored.
Prune Limit Interval
The minimum interval that must transpire between two successive
Prunes sent by a router. This is used only with PIM-DM.
Prunes sent by a router. This is used only with PIM-DM.
Graft Retry Interval
Displays the time-interval a router waits for a Graft acknowledgment
before resending a Graft on the interface. This is used only with PIM-
DM. Values may range from 1 to 65535. The default value is 3.
before resending a Graft on the interface. This is used only with PIM-
DM. Values may range from 1 to 65535. The default value is 3.
SR Priority Enabled
Evaluates to TRUE if all routers on this interface are using the State
Refresh option. This is used only by PIM-DM.
Refresh option. This is used only by PIM-DM.
Operational Status
The current operational status of the corresponding interface. Options
include enabled and disabled. This value indicates whether the IP
interface is operationally up. For example, if PIM is enabled on the
interface, but the IP interface is currently down, this field will display
as disabled. The default setting is disabled. To globally enable or dis-
able PIM on the switch, refer to the
include enabled and disabled. This value indicates whether the IP
interface is operationally up. For example, if PIM is enabled on the
interface, but the IP interface is currently down, this field will display
as disabled. The default setting is disabled. To globally enable or dis-
able PIM on the switch, refer to the
.
Enables or disables the PIM protocol on a specific interface.
output definitions (continued)