Alcatel-Lucent 6850-48 Reference Guide

QoS Policy Commands

page 53-124

OmniSwitch CLI Reference Guide

Configures or deletes a QoS action. A QoS action describes how traffic that matches a particular QoS 
condition should be treated. It may specify a particular set of bandwidth and queue parameters, or it may 
simply specify whether the flow is allowed or denied on the switch.

This section describes the base command. Optional keywords are listed below and described as separate 
commands later in this chapter. (Options may be used in combination but are described separately for ease 
in explanation.) Use the no form for keywords to remove the parameter from the action.

Note that some action parameters may not be supported depending on the platform you are using. Also 
some action parameters may not be supported with some conditions. See the condition table in the 
OmniSwitch AOS Release 6 Network Configuration Guide.

policy action action_name 

[shared]
[priority priority_value]
[maximum bandwidth bps]
[maximum depth bytes] 
[tos tos_value] 
[802.1p 802.1p_value] 
[dcsp dcsp_value] 
[map {802.1p | tos | dscp} to {802.1p | tos| dscp} using map_group]
[permanent gateway ip ip_address]
[port-disable]
[redirect port slot/port]
[redirect linkagg link_agg]
[no-cache]
[{ingress | egress | ingress egress | no} mirror slot/port]

policy no action action_name 

A name for the action, any alphanumeric string.

By default, no drop algorithm is configured for the action, and any queues created by the action are not 
shared.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

accept