Alcatel-Lucent 6850-48 Reference Guide

IP Multicast Switching Commands

OmniSwitch CLI Reference Guide

page 55-107

-> show ipv6 multicast vlan 100

Status: = 

Enabled

Querying: = 

Disabled

Proxying:

= Disabled

Spoofing: = 

Disabled

Zapping: = 

Disabled

Querier Forwarding:

= Disabled

Version: = 

1

Robustness: = 

2

Query Interval (seconds): 

= 125

Query Response Interval (milliseconds): 

= 10000

Last Member Query Interval (milliseconds): 

= 1000

Unsolicited Report Interval (seconds) 

= 1, 

Router Timeout (seconds): 

= 90

Source Timeout (seconds): 

= 30:

Max-group                                       = 23,

Max-group action                                = none

Whether the IPv6 Multicast Switching and Routing is Enabled or Dis-
abled (the default status).You can enable or disable IPv6 Multicast 
Switching and Routing with the 

mand, which is described on 

The current state of MLD querying, which can be Enabled or Disabled 
(the default status). You can enable or disable MLD querying with the 

 command, which is described on 

The current state of MLD proxying on the system, which can be 
Enabled or Disabled (the default status). You can enable or disable 
MLD spoofing with the 

 command, which is 

described on 

The current state of MLD spoofing on the system, which can be 
Enabled or Disabled (the default status). You can enable or disable 
MLD spoofing with the 

 command, which is 

described on 

The current state of MLD zapping on the system, which can be 
Enabled or Disabled (the default status). You can enable or disable 
MLD zapping with the 

 command, which is 

described on 

The current state of MLD querier forwarding on the system, which can 
be Enabled or Disabled (the default status). You can enable or disable 
MLD Querier forwarding with the 

 

command, which is described on 

.

Displays the default MLD version, which can be 1, 2 or 3. Use the 

 command to modify this parameter.

Displays the MLD robustness value, ranging from 1 to 7. Use the 

 command to modify this parameter.

Displays the time (in seconds) between MLD queries. (The default 
value is 125 seconds). You can modify this parameter with the

 command, which is described on