Alcatel-Lucent 6850-48 Reference Guide

Source Learning Commands

OmniSwitch CLI Reference Guide

page 17-15

Displays Source Learning MAC Address Table information. 

show mac-address-table [permanent | learned | quarantined] [mac_address] [slot slot | slot/port] [link-
agg link_agg] [vid | vid1-vid2]

Display static MAC addresses with a permanent status.

Display dynamically learned MAC addresses.

Display MAC addresses quarantined by the Quarantine Manager and 
Remediation (QMR) application.

Enter a MAC Address (e.g., 00:00:39:59:f1:0c).

Enter the slot number for a module to specify that the command should 
include all ports on that module (e.g., 6 specifies all ports on the module 
found in slot 6 of the switch chassis).

Enter the slot number and the physical port number on that module 
(e.g., 3/1 specifies port 1 on slot 3).

Enter a link aggregate ID number (0–31). See 

A single VLAN ID number (1–4094). 

The last VLAN ID number in a range of VLANs that you want to 
configure (e.g. 10-12 specifies VLANs 10, 11, and 12).

By default, information is displayed for all MAC addresses contained in the table.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Note that only one VLAN entry—a single VLAN ID or a range of VLAN IDs— is allowed with this 

command. Multiple entries are not accepted.

• If a static MAC address is configured on a port link that is down or disabled, an asterisk appears to the 

right of the MAC address in the show mac-address-table command display. The asterisk indicates 
that this is an invalid MAC address. When the port link comes up, however, the MAC address is then 
considered valid and the asterisk no longer appears next to the address in the display.