Alcatel-Lucent 6850-48 Guide De Référence
Source Learning Commands
OmniSwitch CLI Reference Guide
September 2009
page 17-15
show mac-address-table
Displays Source Learning MAC Address Table information.
show mac-address-table [permanent | learned | quarantined] [mac_address] [slot slot | slot/port] [link-
agg link_agg] [vid | vid1-vid2]
agg link_agg] [vid | vid1-vid2]
Syntax Definitions
permanent
Display static MAC addresses with a permanent status.
learned
Display dynamically learned MAC addresses.
quarantined
Display MAC addresses quarantined by the Quarantine Manager and
Remediation (QMR) application.
Remediation (QMR) application.
mac_address
Enter a MAC Address (e.g., 00:00:39:59:f1:0c).
slot
Enter the slot number for a module to specify that the command should
include all ports on that module (e.g., 6 specifies all ports on the module
found in slot 6 of the switch chassis).
include all ports on that module (e.g., 6 specifies all ports on the module
found in slot 6 of the switch chassis).
slot/port
Enter the slot number and the physical port number on that module
(e.g., 3/1 specifies port 1 on slot 3).
(e.g., 3/1 specifies port 1 on slot 3).
link_agg
Enter a link aggregate ID number (0–31). See
vid
A single VLAN ID number (1–4094).
vid1-vid2
The last VLAN ID number in a range of VLANs that you want to
configure (e.g. 10-12 specifies VLANs 10, 11, and 12).
configure (e.g. 10-12 specifies VLANs 10, 11, and 12).
Defaults
By default, information is displayed for all MAC addresses contained in the table.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Note that only one VLAN entry—a single VLAN ID or a range of VLAN IDs— is allowed with this
command. Multiple entries are not accepted.
• If a static MAC address is configured on a port link that is down or disabled, an asterisk appears to the
right of the MAC address in the show mac-address-table command display. The asterisk indicates
that this is an invalid MAC address. When the port link comes up, however, the MAC address is then
considered valid and the asterisk no longer appears next to the address in the display.
that this is an invalid MAC address. When the port link comes up, however, the MAC address is then
considered valid and the asterisk no longer appears next to the address in the display.