Alcatel-Lucent 6850-48 Reference Guide
Learned Port Security Commands
page 18-20
OmniSwitch CLI Reference Guide
September 2009
show port-security
Displays Learned Port Security (LPS) configuration and table entries.
show port-security [slot/port[-port2] | slot]
Syntax Definitions
slot/port
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
module (e.g., 3/1 specifies port 1 on slot 3).
-port2
The last port number in a range of ports you want to configure on the
same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
slot
Enter the slot number for a module to specify that the command should
include all ports on that module (e.g., 6 specifies all ports on the module
found in slot 6 of the switch chassis).
include all ports on that module (e.g., 6 specifies all ports on the module
found in slot 6 of the switch chassis).
Defaults
By default, all ports with an LPS configuration are displayed.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Displays ports that have an LPS configuration, even if LPS is disabled on the port.
• Use the slot/port[-port2] parameter with this command to display the LPS configuration for a specific
port or a range of ports.
• Use the slot parameter with this command to display the LPS configuration for all the ports on a
specific slot.
• In addition, MAC addresses that were learned on the LPS port because they fell within the specified
MAC address range, appear as a separate entry in the LPS table with a dynamic MAC type.
• Dynamic MAC addresses become configured MAC addresses in the LPS table when the switch config-
uration is saved and the switch is rebooted. If the configuration is not saved before the next reboot, all
dynamic MAC addresses are cleared from the LPS table.
dynamic MAC addresses are cleared from the LPS table.
• The MAC Type field is blank if an authorized MAC address range is configured for the LPS port.