Alcatel-Lucent 6850-48 Reference Guide
VLAN Management Commands
OmniSwitch CLI Reference Guide
September 2009
page 21-25
show vlan gvrp
Displays a list of VLANs learned through GVRP.
show vlan gvrp [vid1[-vid2]]
Syntax Definitions
vid1
The VLAN ID number (2–4094).
-vid2
The last VLAN ID number in a range of VLANs that you want to
configure (e.g. 10-12 specifies VLANs 10, 11, and 12).
configure (e.g. 10-12 specifies VLANs 10, 11, and 12).
Defaults
By default, all VLANs learned through GVRP are displayed.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
Use the vid parameter with this command to display information for a specific VLAN or for a specific
range of VLANs.
range of VLANs.
Examples
-> show vlan gvrp
stree mble
vlan type admin oper 1x1 flat auth ip ipx tag name
----+-----+-----+----+-----+--------+-------+------+-----+-----+--------------
5
gvrp
on on on on off NA off off
GVRP1
6
gvrp
on on
off off off NA off off
GVRP12
output definitions
vlan
The VLAN ID. Use the
command to create or remove VLANs.
type
The type of VLAN (std, vstk, gvrp, or ipmv)
admin
VLAN administrative status: on enables VLAN functions to operate;
off disables VLAN functions without deleting the VLAN. Use the
off disables VLAN functions without deleting the VLAN. Use the
command to change the VLAN administrative status.
oper
VLAN operational status: on (enabled) or off (disabled). The opera-
tional status remains disabled until an active port is assigned to the
VLAN. When the operational status is enabled, then VLAN properties
(e.g. router interfaces, Spanning Tree) are applied to ports and traffic
flow. A VLAN must have an enabled administrative status before it can
become operationally enabled.
tional status remains disabled until an active port is assigned to the
VLAN. When the operational status is enabled, then VLAN properties
(e.g. router interfaces, Spanning Tree) are applied to ports and traffic
flow. A VLAN must have an enabled administrative status before it can
become operationally enabled.